Vertical shaft hammer crusher

The vertical shaft hammer crusher mainly relies on the impact to break the material. It is the preferred equipment for fine crushing. The crushing ratio is large. Because the main shaft is vertical, the side pulling force produces a large supporting force on the upper and lower bearings, and the working conditions in the machine cavity. The bearing is very easy to damage. In order to protect the bearing work, our company adopts the load-shedding structure to apply the tension of the main shaft to the machine body. The main shaft only bears the torque, improves the working condition of the bearing and reduces the damage of the bearing. The broken inner liner is seriously worn, and the wear resistant material liner is used to increase the service life.

Message

Tel

13324215382

Category:

Regular Products

产品详情

product description

Technical performance and characteristics

High crushing ratio, high yield, low consumption
Broken all kinds of medium hardness and brittle materials, the crushing ratio is large (usually 10-25, the highest is 50), the production capacity is high, the product size is small and uniform, the cube is formed, the powder phenomenon is less, and the energy consumption per unit product is low.

Reasonable structure, stable operation
The utility model has the advantages of simple structure, light equipment quality, easy operation and maintenance, good sealing performance and stable operation; reasonable use of triangular tape to maintain proper tension.

working principle

The hammer crusher mainly relies on the impact to break the material. The material enters the crusher and is broken by the impact of the high-speed rotary hammer. The broken material obtains kinetic energy from the hammer head, and rushes from the high-speed to the baffle inside the frame, and the sieve bar. At the same time, the materials collide with each other. After several times of crushing, the material smaller than the gap of the screen strip is discharged from the gap, and the individual larger material is crushed again by the impact of the hammer head on the screen strip, grinding, crushing, and the material is squeezed from the gap by the hammer head. To get the product of the desired particle size.

Product atlas

Technical Parameters

Model	Production capacity (ton / hour)	Feed granularity (mm)	Rowing granularity (mm)	Motor Power (KW)	Weight(t) (excluding the motor)
PCL750-3	12-15	≤50	≤5	Y200L-4 N=30	2.34
PCL750-4	12-15	≤50	≤5	Y200L-4 N=30	2.75
PCL1000-3	20-25	≤60	≤6	Y280M-6 N=55	4.7
PCL1250-3	35-40	≤70	≤7	Y315M-8 N=75	6.63
PCL1500-3	50-55	≤100	≤8	Y315L2-8 N=110	9.899
PCL1500-4	60-75	<80	<7	Y315M3-8 N=110	11.078